The Drill Hole Problem

Before: Very little PCB between stabilizer hole and the board edge
After: Stabilizer hole extended beyond the PCB

I was expected to receive the prototype of Miuni32 Group Buy 2 more than a week ago. It never materialized in part due to an issue with the location of the stabilizer drill holes. The adjusted location leaves very little space between the bottom of the hole and the edge of the board. This was not a problem with manufacturing. But looking at the sample photos I just lost confidence and I felt like it could become a durability issue very easily.  So I decided to extend the hole (as a slot) to eliminate durability issue altogether. This should be the last change for this revision! Fingers crossed!

Leave a comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.